Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH – Rolling screen installation and operation manual
WARNING: It 's absolutely forbidden to install the screen on mobile walls or unstable cables,the brackets must be applied on surfaces that ensure in the time your distance. When
installing the screen use plugs and screws suitable for the screen's weight and for the type of wall or ceiling on which the mount brackets are to be fixed, based on the following criteria
Screen width up to cm
Overall weight
Made by Adeo Screen Sp. Z o.o. (Poland) Specifications are subject to change without notice. E&OE
Doc: ELEGANCE Installation Manual rev4 | 07.01.2021
Please verify that you are working with the latest revision of this document before specifying your screen.
07 INSTALLATION INSTRUCTIONS
160
Kg 20
QUICK BRACKET VERSION INTALLATION:
1)secure brackets with adequate expansion plugs (min. Ø 8 mm) at approx. 10 - 15 cm from the ends of the case; ceiling or wall mount are
possible; check they are level;
2) fasten screen to brackets as the left pictures
200
250
300
360
Kg 25
Kg 30
Kg 35
Kg 45
WALL INSTALLATION:
Insert screw 4 with thread turned upwards into plate 1 and screw on nut 3
loosely, leaving a 4-5 mm play; hook plate 1 to the case and insert plastic
pin 2 into the slot of the small bracket or the screw. Please note that, for
assembly purpose, the plate can be mounted either way since the hookable
sections of the case are perfectly symmetrical. Secure bracket 5 to the wall
with adequate wall type expansion plugs (min. Ø 8 mm) at approx. 10 - 15
cm from the ends of the case and secure plate 1 to bracket 5 using washer 7
and bolt 3.
CEILING INSTALLATION:
secure ceiling brackets 6 (provided) with adequate wall expansion plugs
(min. Ø 8 mm), at approx. 10 - 15 cm from the ends of the case. For screens
wider than 350 cm, the third bracket must be positioned in the middle of the
case. Insert screw 4 with thread turned upwards into plate 1 and screw on
nut 3 loosely, leaving a 4.5 mm play; hook plate 1 to the case and insert
plastic pin 2 into the slot of the small bracket or the screw. Secure plate 1 to
bracket 6 using washer 7 and bolt 3.
Direct ceiling installation with mount plates:
For closer adherence of the case to the ceiling it is possible to fix mount
plates 1 directly to the ceiling (N.B.: for quick and easy performance of this
operation, excellent ceiling flatness and perfect alignment of the plates are
required). Secure the plates with expansion plugs suitable for the type of
ceiling (min. Ø 8 mm), at approx. 10 - 15 cm from the ends of the case. For
this type of installation, as a rule, the side of the plate in which the pin is to
be slotted should be turned towards the front of the case, to facilitate the
insertion of the pin. Carefully check the alignment and horizontality of the
plates. Metal washers of the type included in the packaging may be used for
the purpose as necessary. Note that an accurate performance of this
operation will ensure ease and speed when subsequently hooking the case
to the plates. For screens wider than 350 cm the third palte must be
positioned in the middle of the case. Hook the case to the plates with a
semicircular movement (until it clicks into position); secure the case to the
plates by inserting the plastic pins.
410
520
620
Kg 50
Kg 100
Kg 150
Page 12
Publicité
Table des Matières
