Urmet 1092 Série Manuel D'utilisation page 21

The options available for LEVEL are: middle, high, low. The function AREA allows to define dimension and
position.
HSBLC is accessed by selecting the following submenu:
SELECT
DISPLAY
BLACK MASK
LEVEL
MODE
DEFAULT
RETURN
The SELECT menu provides 4 areas. For those areas set their position and size (DISPLAY), their
brightness level (0 to 255) and their MODE (ALL DAY and NIGHT, which you can adjust the AGC LEVEL
for) to enable the BLACK MASK . You can use the DEFAULT command to reset the previous values.
Selecting LEVEL allows to choose the desired percentage.
When adjusting the Level, make sure the set up adjusting value is acceptable for both day and night.
Use a low percentage if there is faint light around the light source (to obtain the max. compensation); use a
high percentage if there is bright light around the light source (to obtain the min. compensation).
Note: this menu is not active if the camera is in B/W mode (see DAY & NIGHT MENU).
This function is used to select white balancing mode. Select this menu item to choose among the options in
the table.
Option
ATW
AWB
MANUAL
OUTDOOR-INDOOR

AWC SET
Important note: you should preferably use the ATW option.
DS1092-526
HSBLC
AREA1
ON
ON
■■█■■■■■■■■20
NIGHT
RET
WHITE BAL – WHITE BALANCING
Value
The Auto Tracking White function allows an automatic
/
adjustment based on surrounding environment detection
Auto White Balance mode allows an automatic white
/
balancing when color temperature range (color gamma) is
particularly wide.
Manual adjustment of the colors red and blue. Choose
BLUE ÷ RED
among the values from 0 to 100.
Automatic adjustment based on surrounding environment
/
detection: installations INDOOR or OUTDOOR.
White balancing setting, to be used when a single
adjusting is preferred to automatic adjusting (constant
/
lighting condition). Press the menu button to activate this
function.
Description
21