Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Control channel 2 - Gobo-wheel
DMX-value
Feature
0-17
Open
18-35
Gobo 1
36-53
Gobo 2
54-71
Gobo 3
72-89
Gobo 4
90-107
Gobo 5
108-125
Gobo 6
126-143
Gobo 7
Control channel 3 - Shutter, strobe
DMX-value
Feature
0-14
Shutter closed
15-29
Open
30-250
Strobe-effect with increasing speed
251-255
Open
CLEANING AND MAINTENANCE
The operator has to make sure that safety-relating and machine-technical installations are inspected by an
expert after every four years in the course of an acceptance test.
The operator has to make sure that safety-relating and machine-technical installations are inspected by a
skilled person once a year.
The following points have to be considered during the inspection:
1) All screws used for installing the devices or parts of the device have to be tighly connected and must not
be corroded.
2) There must not be any deformations on housings, fixations and installation spots (ceiling, suspension,
trussing).
3) The electric power supply cables must not show any damages, material fatigue (e.g. porous cables) or
sediments. Further instructions depending on the installation spot and usage have to be adhered by a
skilled installer and any safety problems have to be removed.
We recommend a frequent cleaning of the device. Please use a moist, lint-free cloth. Never use alcohol or
solvents!
The interior of the device should be cleaned at least annually using a vacuum-cleaner or an air-jet.
There are no serviceable parts inside the device except for the lamp and the fuse. Maintenance and service
operations are only to be carried out by authorized dealers.
Please refer to the instructions under "Installing/Replacing the lamps".
DMX-value
Feature
144-161
Gobo 8
162-179
Gobo 9
180-197
Gobo 10
198-215
Gobo 11
216-233
Gobo 12
234-251
Gobo 13
252-255
Gobo 14
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
27/54
00026486.DOC, Version 1.5
Publicité
Table des Matières
