Installing The Skimmer; Maintenance And Use Guidelines - Trigano Jardin OSMOSE Ovale Notice De Montage Et Guide D'utilisation

16.2. Installing the skimmer

When the water level in the pool reaches 5 to 6 cm below the skimmer,
install it using the type of joint included with your skimmer (single or
double). (Figure 4):
■ By pressing on the liner (using, for example, a pen cap), find the pre-
drilled holes in the plate.
■ Stamp the holes using a Philips-head screwdriver.
■ Position the rubber joints according to figure 4.
■ Place the flange (or frame) on the rubber joint.
■ Screw the flange onto the metal sheet.
■ Screw the threaded connector or stopper valve (depending on the
model) with Teflon tape, the pipe and the ring clamp on to the skimmer.
■ Cut out the part of the liner obstructing the skimmer from inside the
pool.
■ Connect the corrugated pipe from the skimmer to the filter pump.
■ Let the water level rise up to the middle of the skimmer.
■ Check the seal and tighten the screws if necessary.
■ Permanent water-resistance will only be obtained after tightening all
the screws progressively and regularly.
For permanent water-resistance, retighten all the screws over the course
of the next few days.
WARNING: Do not tighten the screws of the skimmer and discharge
nozzle until the water level is a few centimetres from the parts to be
installed. The water pressure should stretch the liner out nicely.

17. Maintenance and Use Guidelines

Non-compliance with maintenance instructions may cause serious health risks, particularly for children.
FILTRATION
In order to eliminate suspended solids, you must have a good filtration system. During the season when you are using your pool,
the filtration system must be operated each day, long enough to ensure the water volume is renewed at least every 24 hours (the
minimum filtration duration depends on use and water temperature). We recommend splitting the filtration into 2 periods (once in
the morning and once at night).
Inner wall dimensions =>
Water volume
Filtering capacity
Daily filtration duration
You must:
■ Ensure that suction ports are free of obstructions.
■ Replace any element or set of elements that become deteriorated. Only use parts that have been approved by the
manufacturer.
■ Stop the filtration system during maintenance operations.
■ Periodically check the filter's clogging level.
■ Please consult the filter instructions for filtration system maintenance and use.
■ Check the fill level.
ACCESSORIES
The following accessories are required for proper pool maintenance: surface accessories (example: net), bottom accessories,
monitoring and repair accessories (example: repair kit).
OSMOSE Oval
4.85 x 3.60 m 6.10 x 3.60 m
19 m³ 24 m³
4 m³/h 6 m³/h 4 m³/h
4 hrs 45 3 hrs 15 6 hrs
106
Figure 4
Facade
Liner
Pool interior
Facade
Liner
7.30 x 3.60 m
29 m³
6 m³/h 6 m³/h 8 m³/h
4 hrs 4 hrs 50 3 hrs 30
Single joint
Steel sides
Pool exterior
Double joint
Steel sides
7.6 x 4.6 m 9.20 x 4.60 m
37 m³ 45 m³
8 m³/h 10 m³/h
4 hrs 30 3 hrs 45
Assembly Guide 880115-rev A