Installation Of The Ledge Pieces And Covering Plates - Trigano Jardin OSMOSE Ovale Notice De Montage Et Guide D'utilisation

15. Installation of the ledge pieces and covering plates

The ledge pieces must be assembled in a certain position. The widest edge must be on the outside.
The ledge pieces must be positioned between the posts.
Each ledge piece extremity must be screwed onto a top plate or connecting plate. You may need to gently move the posts to the
left or right to install the ledge pieces. Do not fully tighten the screws until they are all in place.
Fit the covering plates over the extremities of the ledge pieces and centre them. The narrowest part of the covering plate should
be located on the inside of the pool.
WARNING: The covering plates for the round and straight parts of the pool are different.
1171 or 1174
Ledge piece
0341
3472
Ledge piece covering plate
OSMOSE Oval
Straight part
2402
0341
Round part
2475
Interior overlap
104
0341
No diving
No jumping
Shallow water
No diving
No jumping
Shallow water
1171 or 1174
Ledge piece
0341
Assembly Guide 880115-rev A
2476