AKG C 5900 Mode D'emploi page 14

1 Description
Fig. 2: Optional
TM 40 transmitter
module.
2 Interfacing
2.1 General
Refer to sections
2.2 and 2.3.
2.2 Input with
Phantom Power
Fig. 3: Connecting
to a balanced input.
Refer to fig. 3.
2.3 Input with No
Phantom Power
Refer to fig. 3.
14
The C 5900 M is a condenser microphone and therefore needs a
power supply.
The microphone provides a balanced output on a 3-pin male
XLR connector:
Pin 1: ground
Pin 2: hot
Pin 3: return
You can connect the microphone either to a balanced micro-
phone input with or without phantom power or an unbalanced
microphone input.
C 5900
Phantom
M
C 5900
M
1. Use an XLR cable (e.g., the optional MK 9/10 from AKG) to
connect the microphone to a balanced XLR input with
phantom power.
2. Switch the phantom power on. (Refer to the manual of the
unit to which you connected your microphone.)
1. If your mixer provides no phantom power, connect an
optional AKG phantom power supply (N 62 E, N 66 E, B 18,
B 15) between the microphone and the mixer.
You can easily convert the microphone
into a wireless microphone. All you need
to do is remove the XLR connector mod-
ule and replace it with an optional TM 40
transmitter module.
2.3
2.2