Rating Plate - Danby Designer DER244 Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ELECTRICAL CONNECTIONS
ELECTRICAL REQUIREMENTS
CAUTION
For personal safety, do not use an extension cord with this appliance. Remove house fuse or open circuit breaker
before beginning installation.
This appliance must be supplied with the proper voltage and frequency, and connected to an individual properly
grounded branch circuit, protected by a circuit breaker or fuse having amperage as specifi ed on the rating plate. The
rating plate is located under the cooktop. See the Lift-Up Cooktop section in this manual for instructions on how to lift
the cooktop.

Rating plate

1
POWER CORD AND CONDUIT INSTALLATION
A
Remove terminal block cover (on the back of range) by
removing screws using a 1/4" nut driver. Do not discard
these screws.
Back of range
INSTALLATION INSTRUCTIONS
Screw to
remove
terminal
block cover
Terminal block cover
We recommend you have the electrical wiring and hookup
of your range connected by a qualifi ed electrician. After
installation, have the electrician show you where your main
range disconnect is located.
Check with your local utilities for electrical codes which
apply in your area. Failure to wire your oven according to
governing codes could result in a hazardous condition. If
there are no local codes, your range must be wired and
fused to meet the requirements of the CSA Standard C22.1,
Canadian Electrical Code, Part 1 - latest edition. You can get
a copy from:
Canadian Standards Association, 178 Rexdale Blvd.,
Toronto, ON, M9W 1R3, CANADA.
This range is equipped with a CSA International Certi
Power Cord intended to be plugged into a standard 14-50R
wall receptacle. Be sure the wall receptacle is within reach of
the range's fi nal location.
For USA consumers, we recommend you to have the elec-
trical wiring to reinstall a new power if necessary and follow
power cord and conduit installation.
B
Disconnect each line the power cord and keep the screws in their position.
Terminal block
(appearance
may vary)
18
fi ed

Publicité

Table des Matières
loading

Table des Matières