Rating Plate - Danby Designer DER241WC Guide D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ELECTRICAL CONNECTIONS
ELECTRICAL REQUIREMENTS
CAUTION
For personal safety, do not use an extension cord with this appliance. Remove house fuse or open circuit breaker
before beginning installation.
This appliance must be supplied with the proper voltage and frequency, and connected to an individual properly
grounded branch circuit, protected by a circuit breaker or fuse having amperage as specifi ed on the rating plate. The
rating plate is located under the cooktop. See the Lift-Up Cooktop section in this manual for instructions on how to lift
the cooktop.

Rating Plate

ANTI-TIP BRACKET INSTALLATION INSTRUCTIONS
To reduce the RISK OF TIPPING the range, the range must be secured by a properly installed ANTI-TIP BRACKET.
Secure the bracket with the screws provided. See installation instructions for complete details before attempting to install.
NOTE: The installation of the ANTI-TIP bracket must meet all local codes for securing the appliance.
INSTALLATION INSTRUCTIONS
A child or adult can tip the range and be killed.
Install the anti-tip bracket to the wall or fl oor.
Engage the range to the anti-tip bracket by sliding the range back so the anti-tip
arm slides under the anti-tip bracket.
Re-engage the anti-tip bracket if the range is moved.
Failure to do so can result in death or serious burns to children or adults.
We recommend you have the electrical wiring and hookup
of your range connected by a qualifi ed electrician. After
installation, have the electrician show you where your main
range disconnect is located.
Check with your local utilities for electrical codes which
apply in your area. Failure to wire your oven according to
governing codes could result in a hazardous condition. If
there are no local codes, your range must be wired and
fused to meet the requirements of the CSA Standard C22.1,
Canadian Electrical Code, Part 1 - latest edition. You can get
a copy from:
Canadian Standards Association, 178 Rexdale Blvd.,
Toronto, ON, M9W 1R3, CANADA.
This range is equipped with a CSA International Certifi ed
Power Cord intended to be plugged into a standard 14-50R
wall receptacle. Be sure the wall receptacle is within reach of
the range's fi nal location.
WARNING
Tip-Over Hazard
19

Publicité

Table des Matières
loading

Table des Matières