Canceling A Cycle; Changing A Cycle After Dishwasher Is Started; Adding A Dish After Dishwasher Is Started - KENMORE ELITE MICROCLEAN 665.1482 Série Guide D'utilisation Et D'entretien

1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door.
2. Press and hold the CANCEL/DRAIN button until the Cancel/Drain light turns on.
3. Close the door. The dishwasher starts a drain cycle if water remains in bottom of dishwasher. Let the dishwasher drain completely.
The Cancel/Drain light turns off after 2 minutes.
You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure:
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2. Check whether the detergent dispenser cover is still closed. If it is open, you will need to refill the detergent dispenser before
restarting your new cycle.
3. Press and hold CANCEL/DRAIN twice to reset the control.
4. Select new cycles and options.
5. Press START/RESUME.
You may add a dish during the first few minutes of the cycle.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2. Add the dish or other items to the load.
3. Press START/RESUME.
4. Close the door. (The door must be closed within 3 seconds of pressing Start/Resume or the cycle will not resume).

Canceling A Cycle

Changing A Cycle After Dishwasher Is Started

Adding A Dish After Dishwasher Is Started

19