Canceling A Cycle; Changing A Cycle After Dishwasher Is Started; Adding A Dish After Dishwasher Is Started - KENMORE ELITE ULTRACLEAN 665.1479 Série Guide D'utilisation Et D'entretien

1. Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door.
2. Press and hold the Cancel/Drain button until the Cancel/Drain light turns on.
3. Close the door. The dishwasher starts a drain cycle if water remains in bottom of dishwasher. Let the dishwasher drain completely.
The Cancel/Drain light turns off after 2 minutes.
You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, and then open the door completely.
2. If the Add a Dish indicator is lit you may add items to the load.
3. Press START/RESUME.
4. Press and hold CANCEL/DRAIN twice to reset the control.
5. Select new cycles and options.
1. Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2. If the Add a Dish indicator is lit you may add items to the load.
3. Press START/RESUME.
4. Close the door. The door must be closed within 3 seconds of pressing Start/Resume, or the dishwasher will beep several times and
the cycle will not resume.
20

Canceling A Cycle

Changing A Cycle After Dishwasher Is Started

Adding A Dish After Dishwasher Is Started