Accessories; Sécurité Électrique; Sécurité Individuelle - Milwaukee M12 FUEL 0960-20 Manuel De L'utilisateur

Installing the Vacuum Hanger Mounting
Plate
The vacuum comes equipped with a hanger and
attachable mounting plate.
Position the mounting plate as desired, taking into
account the wall orientation.
Mounting plate must be installed on a flat, even sur-
face. An uneven surface could cause the mounting
plate to warp, resulting in possible problems when
installing vacuum.
Use the below recommended fasteners in the four
corner holes.
If installing into wood:
• Install onto dimensional lumber 2x4 (or larger) or
3/4" thick plywood.
• Use four Ø 1/4" x 1-1/4" lag screws.
If installing into concrete:
• Use four suitable concrete anchors.
Storage
Before storing your vacuum, empty and clean the
tank, filter, and accessories. Remove the battery
pack.
MAINTENANCE
WARNING
To reduce the risk of
injury, always unplug
the charger and remove the battery pack from
the charger or tool before performing any main-
tenance. Never disassemble the tool, battery
pack or charger. Contact a MILWAUKEE service
facility for ALL repairs.
Maintaining Tool
Keep your tool, battery pack and charger in good
repair by adopting a regular maintenance program.
Inspect your tool for issues such as undue noise,
misalignment or binding of moving parts, breakage of
parts, or any other condition that may affect the tool
operation. Return the tool, battery pack, and charger
to a MILWAUKEE service facility for repair. After six
months to one year, depending on use, return the
tool, battery pack and charger to a MILWAUKEE
service facility for inspection.
If the tool does not start or operate at full power with
a fully charged battery pack, clean the contacts on
the battery pack. If the tool still does not work prop-
erly, return the tool, charger and battery pack, to a
MILWAUKEE service facility for repairs.
WARNING
To reduce the risk of
personal injury and
damage, never immerse your tool, battery pack
or charger in liquid or allow a liquid to flow inside
them.
Cleaning
Clean dust and debris from vents. Keep handles
clean, dry and free of oil or grease. Use only mild
soap and a damp cloth to clean, since certain clean-
ing agents and solvents are harmful to plastics and
other insulated parts. Some of these include gasoline,
turpentine, lacquer thinner, paint thinner, chlorinated
cleaning solvents, ammonia and household deter-
gents containing ammonia. Never use flammable or
combustible solvents around tools.
Cleaning the Filter
To clean the filter, tap clean, or rinse in water.
NOTE: If cleaning with water, let filter dry 24 hours
before using with vacuum. Replace filter if damaged
or suction decreases.
Repairs
For repairs, return the tool, battery pack and charger
to the nearest authorized service center.

ACCESSORIES

Use only recommended accesso-
WARNING
ries. Others may be hazardous.
For a complete listing of accessories, go online to
www.milwaukeetool.com or contact a distributor.
SERVICE - UNITED STATES
1-800-SAWDUST
(1.800.729.3878)
Monday-Friday, 7:00 AM - 6:30 PM CST
www.milwaukeetool.com
or visit
Contact Corporate After Sales Service Technical
Support with technical, service/repair, or warranty
questions.
Email: metproductsupport@milwaukeetool.com
B e c o m e a H e a v y D u t y C l u b M e m b e r a t
www.milwaukeetool.com to receive important
notifications regarding your tool purchases.
SERVICE - CANADA
Milwaukee Tool (Canada) Ltd
1.800.268.4015
Monday-Friday, 7:00 AM - 4:30 PM CST
or visit www.milwaukeetool.ca
LIMITED WARRANTY
USA & CANADA
Every MILWAUKEE power tool* (see exceptions below) is warranted
to the original purchaser only to be free from defects in material and
workmanship. Subject to certain exceptions, MILWAUKEE will repair
or replace any part on an electric power tool which, after examination,
is determined by MILWAUKEE to be defective in material or workman-
ship for a period of five (5) years** after the date of purchase unless
otherwise noted. Return of the power tool to a MILWAUKEE factory
Service Center location or MILWAUKEE Authorized Service Station,
freight prepaid and insured, is required. A copy of the proof of purchase
should be included with the return product. This warranty does not
apply to damage that MILWAUKEE determines to be from repairs
made or attempted by anyone other than MILWAUKEE authorized
personnel, misuse, alterations, abuse, normal wear and tear, lack of
maintenance, or accidents.
Normal Wear: Many power tools need periodic parts replacement and
service to achieve best performance. This warranty does not cover
repair when normal use has exhausted the life of a part including,
but not limited to, chucks, brushes, cords, saw shoes, blade clamps,
o-rings, seals, bumpers, driver blades, pistons, strikers, lifters, and
bumper cover washers.
*This warranty does not cover Air Nailers & Staplers; Airless Paint
Sprayer; Cordless Battery Packs; Gasoline Driven Portable Power
Generators; Hand Tools; Hoist – Electric, Lever & Hand Chain;
M12™ Heated Gear; Reconditioned Product; and Test & Measure-
ment Products. There are separate and distinct warranties available
for these products.
**The warranty period for Job Site Radios, M12™ Power Port, M18™
Power Source, Jobsite Fan and Trade Titan™ Industrial Work Carts is
one (1) year from the date of purchase. The warranty period for the M18
FUEL™ 1" D-Handle High Torque Impact Wrenches, Drain Cleaning
Cables and AIRSNAKE™ Drain Cleaning Air Gun Accessories is two
(2) years from the date of purchase. The warranty period for the M18™
Compact Heat Gun, 8 Gallon Dust Extractor, M18™ Framing Nailers,
M18 FUEL™ 1/2" Ext. Anvil Controlled Torque Impact Wrench w/ ONE-
KEY™, M18 FUEL™ 1" High Torque Impact Wrench w/ ONE-KEY™,
and the M18 FUEL™ 2 Gal. Compact Quiet Compressor is three (3)
years from the date of purchase. The warranty period for the LED in the
LED Work Light and the LED Upgrade Bulb for the Work Light is the
6
lifetime of the product subject to the limitations above. If during normal
use the LED or LED Bulb fails, the part will be replaced free of charge.
Warranty Registration is not necessary to obtain the applicable war-
ranty on a MILWAUKEE power tool product. The manufacturing date
of the product will be used to determine the warranty period if no proof
of purchase is provided at the time warranty service is requested.
ACCEPTANCE OF THE EXCLUSIVE REPAIR AND REPLACEMENT
REMEDIES DESCRIBED HEREIN IS A CONDITION OF THE CON-
TRACT FOR THE PURCHASE OF EVERY MILWAUKEE PRODUCT.
IF YOU DO NOT AGREE TO THIS CONDITION, YOU SHOULD NOT
PURCHASE THE PRODUCT. IN NO EVENT SHALL MILWAUKEE BE
LIABLE FOR ANY INCIDENTAL, SPECIAL, CONSEQUENTIAL OR
PUNITIVE DAMAGES, OR FOR ANY COSTS, ATTORNEY FEES,
EXPENSES, LOSSES OR DELAYS ALLEGED TO BE AS A CON-
SEQUENCE OF ANY DAMAGE TO, FAILURE OF, OR DEFECT IN
ANY PRODUCT INCLUDING, BUT NOT LIMITED TO, ANY CLAIMS
FOR LOSS OF PROFITS. SOME STATES DO NOT ALLOW THE EX-
CLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL
DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT
APPLY TO YOU. THIS WARRANTY IS EXCLUSIVE AND IN LIEU
OF ALL OTHER EXPRESS WARRANTIES, WRITTEN OR ORAL.
TO THE EXTENT PERMITTED BY LAW, MILWAUKEE DISCLAIMS
ANY IMPLIED WARRANTIES, INCLUDING WITHOUT LIMITATION
ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS
FOR A PARTICULAR USE OR PURPOSE; TO THE EXTENT SUCH
DISCLAIMER IS NOT PERMITTED BY LAW, SUCH IMPLIED WAR-
RANTIES ARE LIMITED TO THE DURATION OF THE APPLICABLE
EXPRESS WARRANTY AS DESCRIBED ABOVE. SOME STATES
DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WAR-
RANTY LASTS, SO THE ABOVE LIMITATION MAY NOT APPLY TO
YOU, THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS,
AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH VARY FROM
STATE TO STATE.
This warranty applies to product sold in the U.S.A. and Canada only.
Please consult the 'Service Center Search' in the Parts & Service sec-
tion of MILWAUKEE's website www.milwaukeetool.com or call 1.800.
SAWDUST (1.800.729.3878) to locate your nearest service facility for
warranty and non-warranty service on a Milwaukee electric power tool.
Model:
Date of Purchase:
Distributor or Store Stamp:
RÈGLES
GÉNÉRALES DE
SÉCURITÉ
AVERTISSEMENT
L O R S D E L'U T I L I S AT I O N D'U N
ASPIRATEUR ÉLECTRIQUE, DES
PRÉCAUTIONS ÉLÉMENTAIRES, Y
COMPRIS CELLES PRÉSENTÉES
CI-DESSOUS, DOIVENT TOUJOURS
ÊTRE PRISES EN COMPTE : LIRE
TOUTES LES INSTRUCTIONS AVANT
D'UTILISER L'ASPIRATEUR. AVANT
D'UTILISER L'ASPIRATEUR, LIRE LE
PRÉSENT MANUEL D'UTILISATION,
LE MANUEL D'UTILISATION DU
BLOC-PILES ET DU CHARGEUR,
AINSI QUE TOUTES LES ÉTIQUETTES
SE TROUVANT SUR L'ASPIRATEUR,
LE BLOC-PILES, ET LE CHARGEUR.
NE PAS SUIVRE L'ENSEMBLE DES
AVERTISSEMENTS ET INSTRUC-
TIONS PEUT ENTRAÎNER UN CHOC
ÉLECTRIQUE, UN INCENDIE ET/OU
DES BLESSURES GRAVES.
SÉCURITÉ DU LIEU DE TRAVAIL
• Veuillez conservez votre zone de travail propre et
bien éclairée. Les zones encombrées ou sombres
sont propices aux accidents.
• Les aspirateur et autres pièces pouvant produire
des étincelles durant leur fonctionnement nor-
mal. Veuillez conserver une distance de 10 mètres
avec les zones pouvant contenir des matières
explosives (tels que des pompes à essence et
des endroits où des produits comme du diluant à
peinture, des produits nettoyants, des solvants, etc.
sont stockés).
• Ne pas utiliser en présence de poussières, liq-
uides ou vapeurs explosives.
• Ne pas utiliser là où de l'oxygène ou des anes-
thésiants sont utilisés.
• Interdire son utilisation comme un jouet. Portez
une attention particulière lorsque l'appareil est utilisé
par ou proche d'enfants.
• Utilisez des soins supplémentaires lors de
l'utilisation sur les escaliers
SÉCURITÉ ÉLECTRIQUE
• N'aspirez pas de matériaux humides. N'utilisez
pas d'eau pour contenir la poussière.
• Ne pas manipuler la batterie ou le aspirateur
mains mouillées.
SÉCURITÉ INDIVIDUELLE
• RESTEZ ATTENTIF Restez attentif à ce que vous
faites et utilisez votre bon sens. N'utilisez pas le
dépoussiéreur si vous êtes fatigué, distrait ou sous
l'influence de drogues, d'alcool ou d'une médication
pouvant entraîner une diminution de votre contrôle.
7