Installation; Connection Cable; Before The Installation - Zanussi ZEL6640XBA Notice D'utilisation

Problem
and a number come on.
comes on.
If you cannot find a solution...
If you cannot find a solution to the problem
yourself, contact your dealer or an Authorised
Service Centre. Give the data from the rating
plate. Give also three digit letter code for the
glass ceramic (it is in the corner of the glass
surface) and an error message that comes on.

Installation

WARNING!
Refer to Safety chapters.

Before the installation

Before you install the hob, write down the
information bellow from the rating plate. The
rating plate is on the bottom of the hob.
Serial number ...........................
Built-in hobs
Only use the built-in hobs after you assemble
the hob into correct built-in units and work
surfaces that align to the standards.
www.zanussi.com
Possible cause
The diameter of the bottom of the
cookware is too small for the
zone.
There is an error in the hob.
There is an error in the hob be-
cause a cookware boiled dry. Au-
tomatic Switch Off and the over-
heating protection for the zones
operate.
Make sure, you operated the hob correctly. If
not the servicing by a service technician or
dealer will not be free of charge, also during the
warranty period. The instructions about the
Service Centre and conditions of guarantee are
in the guarantee booklet.

Connection cable

• For a single phase or two phase connection
Use cookware with correct di-
mensions.
Refer to "Technical information"
chapter.
Disconnect the hob from the
electrical supply for some time.
Disconnect the fuse from the
electrical system of the house.
Connect it again. If
again, speak to an Authorised
Service Centre.
Deactivate the hob. Remove the
hot cookware. After approximate-
ly 30 seconds, activate the zone
again. If the cookware was the
problem, the error message goes
out. Residual heat indicator can
stay on. Let the cookware be-
come sufficiently cool. Check if
your cookware is compatible with
the hob.
Refer to "Hints and tips" chapter.
use the following (or higher) mains cable
type: H05V2V2-F T min 90°C.
Remedy
comes on
13