General Guidelines - Velleman VTLLAMP16 Mode D'emploi

Keep away from excessive heat and direct sunlight.
The housing might heat up during usage. Keep minimum distances around
the device for sufficient ventilation. Place the device on a flat, heat-resistant
surface. Do not place the device on carpets, fabrics...
Where the mains plug or an appliance coupler is used as the disconnect
device, the disconnect device shall remain readily operable.
If the external flexible cable or cord of this luminaire is damaged, it shall be
replaced by a special cord or cord exclusively available from the
manufacturer or his service agent.
Never leave the magnifying lens unattended where direct sunlight may pass
through it: this creates a fire hazard. Close the lens cover after use.
Indoor use only.
Do not use the luminaire with a cracked or broken protective shield.
Disconnect immediately from the mains.
Not suitable for ordinary lighting in household room illumination.
3.

General Guidelines

Refer to the Velleman
manual.
All modifications of the device are forbidden for safety reasons. Damage caused
by user modifications to the device is not covered by the warranty.
Only use the device for its intended purpose. Using the device in an unauthorised
way will void the warranty.
Damage caused by disregard of certain guidelines in this manual is not covered
by the warranty and the dealer will not accept responsibility for any ensuing
defects or problems.
Nor Velleman nv nor its dealers can be held responsible for any damage
(extraordinary, incidental or indirect) – of any nature (financial, physical...)
arising from the possession, use or failure of this product.
Keep this manual for future reference.
4. Operation
Clip the lamp onto a flat, horizontal and non-slippery surface.
Connect to the mains and switch on.
Switch off and disconnect from the mains after use.
V. 01 – 07/12/2017
VTLLAMP16
® Service and Quality Warranty on the last pages of this
4 ©Velleman nv