Before You Start; Assembly - Echo PB-265ESLT Manuel D'utilisation

Before you start

Assembly

Read the operator's manual carefully to ensure that you assemble the product correctly.
Never perform maintenance or assembly procedures with engine running.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
Install blower pipes
1. Elbow
3. Flexible pipe
5. Opening side
1. Flexible pipe
3. Throttle cable
5. Swivel pipe
7. Pinch
1. Swivel pipe
3. Round bent nozzle
WARNING
2. Clamp with guide loop
4. Clamp
6. Around midway
2. Clamp
4. Knob
6. Handle
8. Open
2. Straight pipe
Before you start
1. Assemble clamps onto both ends of flexible pipe.
NOTE
Clamp with cable guide loop fits elbow end of flexible pipe.
2. Assemble flexible pipe to elbow on blower. Place clamp with
guide loop around midway between end of flexible pipe and
bellows. Position guide loop from the downside to the out-
side of flexible pipe and tighten clamp.
NOTE
A light lubricant may be used to ease assembly of flexible pipe
to blower elbow.
NOTE
Hang handle freely from blower to assure throttle cable is not
twisted before installing handle.
3. Position throttle cable underneath the elbow and along the
side of the flexible pipe. Loosen knob on handle. Align notch
in handle with tabs. Install onto swivel pipe past long ridges
in pipe.
4. Assemble swivel pipe into flexible pipe and tighten clamp.
5. Clip throttle cable into throttle cable guide loop.
6. Position handle for comfortable operation, and firmly tighten
the knob by hand.
7. Assemble straight pipe onto swivel pipe, until you feel light
resistance. Do not force connection. Hold swivel pipe and
turn straight pipe clockwise, engaging positive locking chan-
nels, until connection is firm. Do not force connection.
8. Assemble round bent nozzle to straight pipe as in step 7.
NOTE
Blower use will eventually loosen pipe connections. Exclusive
positive locking system allows pipes to be tightened. If loosen-
ing occurs, remove straight pipe and round bent nozzle and in-
stall according to instructions 7 & 8.
14