Before You Start; Assembly - Echo PB-250 Manuel D'utilisation

Before you start

Assembly

Read the operator's manual carefully to ensure that you assemble the product correctly.
Never perform maintenance or assembly procedures with engine running.
Using a product that has been incorrectly assembled could lead to an accident or serious injury.
Install blower pipes
1. Blower pipe(main pipe)
1. Blower pipe(main pipe)
Remove blower pipes
WARNING
2. Blower pipe(fan head
nozzle)
Before you start
1. Stand unit upright on blower base.
2. Align locking ribs (A) on the blower pipe (main pipe) with re-
cesses (B) in fan case. Assure short locking rib (C) faces
downward. Slide the blower pipe (main pipe) into fan case
until a clicking sound is heard.
3. Align tabs (D) with grooves (E) and slide the blower pipe (fan
head nozzle) over the blower pipe (main pipe) until there is
light resistance. Do not force connection.
4. Hold the blower pipe (main pipe), and turn the blower pipe
(fan head nozzle) clockwise, engaging positive locking chan-
nels until connection is firm. Do not force connection.
NOTE
Blower use will eventually loosen pipe connections. Exclusive
positive locking system allows pipes to be tightened. If loosen-
ing occurs, remove the blower pipe(fan head nozzle) and in-
stall according to instructions 3 & 4.
1. Insert screwdriver (F) into hole located near lock symbol (G)
to release pipe lock.
Screwdriver tip may stick out opposite side of locking
hole.
2. Pull pipes out of fan cace.
3. Remove screwdriver.
14
CAUTION