Bosch GSH 7 VC Professional Notice Originale page 9

OBJ_BUCH-1851-003.book Page 9 Monday, August 22, 2016 12:19 PM
 To save energy, only switch the power tool on when using it.
 Always wait until the machine has come to a complete
stop before placing it down. The tool insert can jam and
lead to loss of control over the power tool.
 Restarting Protection
In chiselling mode, the restarting protection prevents un-
controlled starting of the machine after a power failure.
– To restart the operation, switch the On/Off switch to
the Off position and start the machine again.
 Products sold in GB only: Your product is fitted with a
BS 1363/A approved electric plug with internal fuse
(ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it should
be cut off and an appropriate plug fitted in its place by an
authorised customer service agent. The replacement plug
should have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
Products sold in AUS and NZ only: Use a residual current
device (RCD) with a rated residual current of 30 mA or
less.
Symbols
The following symbols are important for reading and under-
standing the operating instructions. Please take note of the
symbols and their meaning. The correct interpretation of the
symbols will help you to use the machine in a better and safer
manner.
Symbol Meaning
GSH 7 VC: Demolition Hammer
Grey-marked area: Handle (insulated
gripping surface)
Article number
Read all safety warnings and all instruc-
tions
Before any work on the machine itself,
pull the mains plug from the socket out-
let
Wear protective gloves
Always wear ear protection.
Wear safety glasses/goggles
Bosch Power Tools
Symbol Meaning
Movement direction
Reaction direction
Next step of action
Prohibited action
Chiselling
Vario-Lock
Switching On
Switching Off
On/Off switch lock-on
Releasing the On/Off switch
Low speed/impact rate
High speed/impact rate
Tool holder
Apply a light coat of grease to the shank
end of the application tool
Service Indicator
P Rated power input
1
E Impact energy per stroke according to
EPTA-Procedure 05/2009
n Impact rate
S
Restarting Protection
Concrete
Brickwork
Weight according to
EPTA-Procedure 01:2014
Protection class
L Sound power level
wA
English | 9
1 609 92A 2BM | (22.8.16)