DeWalt DXCMV5018055 Guide D'utilisation page 26

CODE POSSIBLE CAUSE
6 Compressor is not large enough for accessory
7 Hole in air hose
8 Unit operating in damp or humid conditions
9 Restricted air intake filter
10 Loose belt
11 Loose pulley
Loose flywheel
12
Carbon build-up in pump
13
Belt to tight
14
Pulley misalignment
15
16 Pump oil is low
Detergent type oil being used in pump
17
Extremely light duty cycles
18
Piston rings damaged or worn
19
POSSIBLE SOLUTION
Check the accessory air requirement. If it is higher than the SCFM
or pressure supplied by your air compressor, a larger compressor
is needed to operate accessory.
Check and replace air hose, if required.
Move unit to a dry well ventilated area.
Clean or replace air intake filter.
Check belt tension, see Adjusting Belt Tension under
Maintenance.
Tighten pulley set screw, torque to 85-90 in.-lbs. (9.6–10.2 Nm).
Tighten flywheel screw,
(20.0–24.4 Nm).
Contact a D WALT factory service center or a D
e
service center.
Check belt tension, see Adjusting Belt Tension under
Maintenance.
See Motor Pulley/Flywheel Alignment under Maintenance.
Add synthetic blend, non-detergent air compressor oil to pump.
See Compressor Pump Oil under Maintenance.
Drain oil and refill pump with synthetic blend non-detergent air
compressor oil.
Run unit for longer duty cycles. It is recommended to run at high
throttle 50-75% of the run time and idle for 25% of the run time.
Contact a D WALT factory service center or a D
e
service center.
26
torque to 14–18 ft.-lbs.
WALT authorized
e
WALT authorized
e