Installing The Oven; Setting The Clock - Domo DO2923 Mode D'emploi

DO2923
freely.
4. Food and containers should always be placed on the glass turntable for cooking.
5. If the glass turntable or the ring is cracked, contact your service centre.

INSTALLING THE OVEN

Remove all packaging materials and accessories. Check the oven for any damage such
as dents and ensure the door closes properly. Do not use the oven if any damage is
found. Remove the plastic film surrounding the appliance. This film prevents scratches
during manufacture and transport. However, do not remove the light brown mica
protection on the inside of your oven.
1. Choose a location to install your microwave oven where there is plenty of open
space to allow air movement to and from the appliance. The minimum height
for installing the oven is 85cm. Place the back of the oven against the wall. A
minimum space of 30cm above the appliance should be left open. Between the
oven and other walls, a minimum space of 20cm should be left open.
2. Never remove the feet on the bottom of the microwave oven.
3. A blocked air inlet or outlet may result in damage to the oven.
4. Place the oven as far away from radio and TV as possible, to avoid interference.
5. Insert the microwave oven plug into
the socket. Ensure the voltage in your
home corresponds to the voltage
indicated on your oven.
6. Warning: Do not install the oven
above a stove or other heat-producing
device.
7. The accessible portion of the oven
may become warm during use.

SETTING THE CLOCK

When you plug the oven into the socket, the display shows 0:00 and one beep is heard.
• Press the CLOCK/KITCHEN TIMER button. The display shows 00:00 and the
hour indicator flashes.
• Turn the knob to adjust the hour.
• Press the CLOCK/KITCHEN TIMER button again and the minute indicator
flashes.
• Turn the knob to adjust the minutes.
• Confirm the set time by pressing the CLOCK/KITCHEN TIMER button again.
Pressing the STOP/CLEAR button will cancel the setting of the time.
MICROWAVE
• Press the MICROWAVE button once and the display indicates: P100.
• You can adjust the power incrementally by pressing MICROWAVE or turning the
knob. You can select between P100, P80, P50, P30 or P10. The numbers are the
52