Filling The Clean Water Tank; Fill Level Indicator - Numatic CRG 8055/100T Notice Originale

Machine Set-up Guide
!
Always ensure that the machine is switched off before making any adjustments.

Filling the Clean Water Tank

The CRG 8055 / 8072 is equipped with a large capacity 80 litre clean water tank, allowing for large areas to be covered in a single fill.
10
To fill clean water tank extend fill hose.
NOTE: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not allowed to enter the clean water
tank during the filling process. If using a bucket or similar, ensure it is always clean and free from debris.

Fill Level Indicator

Fill Level Indicator
When filling the clean water tank, do not fill
above the clean water tank emptying hose
retaining clip.
This can be found at the rear of
the machine.
!
14
www.numatic.co.uk
Remove rubber seal and fill.
If you need to access the batteries, make sure that the
waste water tank is empty before lifting.
Alternatively remove filler cap completely.
!
!