Fitting The Brush; Filling The Clean Water Tank; Fill-Level Indicator - Numatic Tro 650G / 200T Notice Originale

Fitting the Brushes
Featuring the OBS (Octagonal Brush System);
the brushes simply push-fit up onto the chucks
making fitting and removal a simple process.
Pull the side pod adjustment lever and set to the top position (Fig.14).
The side pod will now pull open (Fig.15).
Fit outer brush next on both sides (Fig.16).
Close side pod.
Safety gloves are recommended for the changing of used brushes.
14
Filling the Clean-water Tank
The TRO 650 / 200T is equipped with a large capacity 120 litre clean-water tank allowing, for large areas to be covered in a single fill.
To fill the clean-water tank, lift the cover flap (Fig.17) to expose the filler cap.
Unscrew the filler cap (Fig.18) and fill the tank using a hose (Fig.19) or preferred method.
17
!
Note: Great care must be taken to ensure that contaminants (leaves, hair, dirt, etc.) are not
allowed to enter the clean-water tank during the filling process. If using a bucket or similar,
15
18
ensure it is always clean and free from debris.
20
Machine Set-up Guide
16
19

Fill-level indicator

The water level in the clean-water
tank can be measured using the
scale on the rear of the machine
(Fig.20).
Always ensure that the waste-water
tank is empty before lifting.
www.numatic.co.uk
!
14