Raise / Lower Brush Deck; Filling The Clean Water Tank; Fill Level Indicator - Numatic TRG 720/200T Notice Originale

Raise brush deck / Lower brush deck
1
A
After preparing the floor, we are now ready to set the controls to suit the cleaning conditions.
Before any settings can be applied, ensure the brush deck is lowered.
While depressing left-hand foot pedal (1), press down the release lever (2) and gently release the foot pedal to lower the brush deck (3).

Filling the clean water tank

The TRG 720 is equipped with a large capacity 120 litre clean water tank allowing for large areas to be covered in a single fill.
1
A

Fill level indicator

!
2
2
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS.
Machine set-up guide
3
3
To fill the clean water tank, lift the cover flap (Fig.1) to expose the
filler cap.
Unscrew the filler cap (Fig.2) and fill the tank using a hose (Fig.3)
or preferred method. Add cleaning chemical to the tank following
the manufactures guidelines.
Note: A filter basket ensures that contaminants (i.e. leaves,
hair, dirt, etc.) are not allowed to enter the clean water tank
during the filling process. Periodically inspect and clean if
necessary.
Fill-level indicator
The water level in the clean water tank can be measured using the
visible red float inside the clean water dump hose on the rear of
the machine.
Do not overfill the clean water tank.
!
T (+ 44) 01460 68600
13