Fitting Side Pod Skirts; Fitting The Brush - Numatic TRG 720/200T Notice Originale

Machine set-up guide
!
Fitting the side pod skirts
1
To fit the side pod skirts, first remove the steel retaining strip already fitted to the pod (Fig.1).
Align the steel retaining strip within the locating grooves of the rubber skirt and refit using existing screws (Fig.2).
Periodically the side skirts should be examined and checked for wear and damage. Replace as shown above.
!

Fitting the brush

Pull the side pod lever and set to the top position (Fig.1). The side
pod will now pull open.
Slide brush under the chuck and raise into place, turn the brush
anti-clockwise to locate and lock into position. Repeat the
process with the second brush on the opposite side. Close side
pod and move pod lever back into the locked position.
!
SAFETY GLOVES ARE RECOMMENDED FOR
THE CHANGING OF USED BRUSHES.
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS.
1
2
Brush location
!
!
T (+ 44) 01460 68600
11