Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
English
ROTARY HAMMER SAFETY WARNINGS
1.
Wear ear protectors
Exposure to noise can cause hearing loss.
2.
Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3.
Hold power tool by insulated gripping surfaces,
when performing an operation where the cutting
accessory may contact hidden wiring or its own
cord. Cutting accessory contacting a "live" wire
may make exposed metal parts of the power tool
"live" and could give the operator an electric shock.
SPECIFICATIONS
Voltage (by areas)*
Power input
Capacity
No load speed
Full-load impact rate
Weight (without cord, side handle)
*Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) Case ............................................................................. 1
(2) Side Handle ................................................................ 1
(3) Stopper ........................................................................ 1
(4) Hammer Grease A .................................................... 1
Standard accessories are subject to change without
notice.
OPTIONAL ACCESSORIES (sold separately)
1. Through-hole drilling (Rotation + Hammering)
(1) Drill bit (SDS max shank)
Outer diameter (mm)
16
19
22
25
28
32
38
40
7
Overall length (mm)
340, 540
320, 520
370, 570
4.
Do not touch the bit during or immediately after
operation. The bit becomes very hot during
operation and could cause serious burns.
5.
Before starting to break, chip or drill into a wall,
floor or ceiling, thoroughly confirm that such items
as electric cables or conduits are not buried inside.
6.
Always hold the body handle and side handle of
the power tool firmly. Otherwise the counterforce
produced may result in inaccurate and even
dangerous operation.
7.
Wear a dust mask
Do not inhale the harmful dusts generated in
drilling or chiseling operation. The dust can
endanger the health of yourself and bystanders.
(110 V, 115 V, 120 V, 127 V, 220 V, 230 V, 240 V)
950 W*
Drill bit: 40 mm
Core bit: 105 mm
240 – 480 min
1320 – 2650 min
6.8 kg
2. Anchor hole drilling (Rotation + Hammering)
Drill bit (Taper shank)
(1) Drill bit (taper shank)
External dia.: 11, 12.3, 12.7,
14.3, 14.5,
17.5 mm
Taper shank
Application drill bit
adapter
Morse taper
Drill bit (taper shank)
(No. 1)
11, 12.3, 12.7, 14.3, 14.5, 17.5 mm
Adapter for SDS-plus shank bit
(1) Drill bit
(SDS-plus shank)
3. Large dia. hole boring (Rotation + Striking)
(Guide
(1) Center
plate)
pin
-1
-1
(3) Cotter
(2) Taper shank
adapter
(SDS max shank)
(2) Adapter for SDS-plus
shank bit
(SDS max shank)
(3) Core bit
(2) Core
bit
shank
Publicité
Table des Matières
