UWELL Hypercar KIT Manuel D'utilisation page 70

UWELL Hypercar – Using the Device
68
Note: If the vaping voltage is too low, the output power will not be capable of
reaching the desired pre-settings, since the output power automatically adapts.
Settings in TC Mode (Ni200, SS316)
Push the up or down buttons in temperature mode to set the temperature from
100 °C to 315 °C or from 200 °F to 600 °F. In order to change the unit of tempe-
rature from Fahrenheit (F) to Celsius (C), increase the temperature value to the
maximum or minimum level. If you change the set value even further above or
below this range, the display will automatically switch to the other unit.
In TC mode, the atomizer head resistance must be determined. To do
this, select TC mode and then press the fire button, so that "New Coil?" and
"Same Coil?" appear on the display. If it is a new head, confirm this using either