UWELL Hypercar KIT Manuel D'utilisation page 69

UWELL Hypercar – Using the Device
67
Selecting the Operation Modes
Push the fire button three times quickly in succession in order to open the
mode selection. By pressing the adjustment buttons you can change between
the modes Variable Wattage (POWER), Temperature Control Nickel (Ni200),
Temperature Control Stainless Steel (SS316) and Bypass (Mech). Press the fire
button to confirm your settings.
Settings in Variable Wattage Mode (Power)
Press the Up or Down button in Power mode to set the watt value Hold down
the corresponding button to change the value more quickly. The watt settings
can be configured from 5 to 80 watts. If you drop below 5 watts or exceed
80 watts, you will automatically switch to the highest or lowest watt value.