Installing The Evaporating Flask; Adjusting The Angle Of The Evaporating Flask - Heidolph Laborota 4000 efficient Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

4.5.5
WARNING
CAUTION
4.5.6
CAUTION
WARNING
1.02

Installing the evaporating flask

Danger of glass breakage!
Risk of severe injury due to broken glass.
Check glass parts for damage (cracks, chips, etc.)
Use only glass parts that are in flawless condition.
Handle with care.
Drive rotating unintentionally!
Danger of injury to hands.
Ensure that the rotation is turned off.
Install the evaporating flask on the vapour tube with a conical-joint clamp.

Adjusting the angle of the evaporating flask

The angle of the evaporating flask can be adjusted by turning the drive.
Drive rotating unintentionally!
Danger of injury to hands.
Ensure that the rotation is turned off.
Danger of glass breakage!
Risk of severe injury due to broken glass.
Check glass parts for damage (cracks, chips, etc.)
Use only glass parts that are in flawless condition.
Handle with care.
1. Grasp the condenser with your right hand.
Laborota 4000/4001 efficient, 4010/4011 digital, 4002/4003 control
Setup and initial use
93

Publicité

Table des Matières
loading

Table des Matières