BDS Maschinen MAB 455 Mode D'emploi page 47

Using the drill chuck
MAB 455
Inserting the tool
Push the drill chuck onto the tapered mandrel and push the
‹
combination into the morse taper (3) of the machine.
Open the drill chuck and insert the tool into the drill chuck.
‹
Close the drill chuck by hand and then tighten the drill chuck
‹
with the chuck key.
Removing the tool
Unlock the drill chuck with the chuck key and remove the
‹
tool.
WARNING
Risk of injury!
► Tighten the drill chuck only with the chuck key provided.
► Always remove the chuck key from the drill chuck after tight-
ening or loosening.
Preparations
47