Battipav EXTRA 3300 Superlunga Mode D'emploi page 26

GB
• The inclination adjustment knobs are properly
tightened.
TO MOVE THE MACHINE
4
Use a 4 (four)-arm tie rod, making use of the
hooks in the transport handles.
5
TO MOVE THE MACHINE, USE A FOUR-ARM
TIE ROD WITH THE CAPACITY TO LIFT 200 KG
OR AT LEAST 20% MORE THAN THE MACHINE
WEIGHT.
USE LIFTING EQUIPMENT TO MOVE THE MACHINE
POSITIONING
6
Once the machine is raised, lower a leg at a time
and lock it with the specific locking pin. Place the
machine on a stable and perfectly level surface.
CAUTION!
7
Fit the transport wheels to the legs on the rear
side.
8
Lay the machine onto the surface.
9 10
Level the machine on both sides
by adjusting the position of the legs
(A and B)
11
Fit the additional working tables supplied
together with the machine:
12
• Use a 17-mm spanner to loosen the side nuts
that fasten the working tables.
13
• Fit the additional working table by inserting the
fastening eyelet on the locking screw.
CAUTION!
14
Bring all the working tables to the same axis
before locking.
Adjust height by acting on the legs.
15
• Lock the table by tightening the screws in the
frame.
16
• Make sure that the tile bearing square of the
additional working table is aligned with those
of the working table of the machine.
26
CHECKING BEFORE USE
THE EXTRA SAW HAS BEEN DESIGNED FOR
WORKING EXCLUSIVELY WITH WATER.
17
Before any cutting operation, make sure that the
water level inside the tank is correct.
MAKE SURE THAT THE PUMP IS FULLY IMMERSED.
IF IT IS NOT, CHECK THAT THE MACHINE IS
CORRECTLY LEVELLED.
CAUTION!
ADJUSTMENT OF COOLING WATER
18 Through an on-off valve placed on the disk
protection, the water flow can be adjusted
according to the type of material to be cut. An
innovative cooling system makes it possible and
allows the disk to be always wet.
CONNECTING TO POWER SUPPLY
CAUTION
The machine is to be connected to the power supply
by a residual current circuit breaker (RCCB) with the
following characteristics:
RCCB
Transformer
N.B. To ensure correct functioning, periodically
check the efficiency of RCCBs by pressing the
push-button on the front of the device.
• Make sure that the section of the power supply
cable cores has been measured according to the
starting current and its length.
For cables up to 50 m long, a section of 2.5 mm
is enough.
• Before connecting the machine to the power
socket, check that the power supply voltage
corresponds to that shown on the plate on the
machine.
• The machine must be connected to an effective
earth wire.
In case of doubt, do not connect the machine.
Battipav srl
In 10 A Id 30 mA
230 V 50 Hz 2000 W
Transformer
2