Jennair W11312506A Instructions D'utilisation page 17

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

■ It is essential that operational, maintenance, and filter
replacement requirements be carried out for the product
to perform as advertised. Property damage can occur if all
instructions are not followed.
■ The disposable cartridge must be changed at least every 6
months.
■ Use replacement filter UKF8001, Part #EDR4RXD1/
EDR4RXD1B. 2015 suggested retail price of $49.99 U.S.A./
$49.95 Canada. Prices are subject to change without notice.
■ The filter monitor system measures the amount of water that
passes through the filter and alerts you when it is time to
replace the filter. To learn how to check the water filter status,
see "Using the Controls" or "Water Filtration System" in the
Quick Start Guide.
■ After changing the water filter, flush the water system. See
"Water and Ice Dispensers" or "Water Dispenser".
■ These contaminants are not necessarily in your water supply.
While testing was performed under standard laboratory
conditions, actual performance may vary.
*Class I particle size: >0.5 to 1 um
***Compliant for Lead reduction requirements under NSF/ANSI Standard 53 as tested by Pace Analytical
Services, Inc.
Based on the use of Cryptosporidium parvum oocysts
††
Fibers greater than 10 um in length
NSF is a registered trademark of NSF International.
®
■ The product is for cold water use only.
■ The water system must be installed in compliance with state
and local laws and regulations.
■ Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system. Systems certified for cyst reduction may be used
on disinfected waters that may contain filterable cysts. EPA
Est. No. 69625-CT-001.
■ Refer to the "Warranty" for the Manufacturer's limited warranty,
name and telephone number.
Application Guidelines/Water Supply Parameters
Water Supply
Potable City or Well
Water Pressure
35 psi - 120 psi (241 kPa - 827 kPa)
30 psi - 120 psi (207 kPa - 827 kPa)
Water Temperature
33° - 100°F (0.6° - 37.8° C)
Service Flow Rate
0.70 GPM (2.65 L/min.) @ 60 psi.
(413.7 kPa)
■ Your water filtration system will withstand up to 120 pounds per
square inch (psi) water pressure. If your water supply is higher
than 80 psi, install a pressure reducing valve before installing
the water filtration system.
17

Publicité

Table des Matières
loading

Table des Matières