Temperature Control - Siemens S1 RKM 10012 Mode D'emploi

4
18. 0
start stop
<
Temperature
control
5
18. 0 18. 0
start stop
If the batteries on the remote control run out,
then you can still operate the appliance by fitting
the control into its housing on the appliance.
Warning!
When inserting the remote control in its
housing on the panel, make sure to do so in the
right position, with the digital display screen on
your left.
Always try to aim the remote control at the front
of the appliance to improve signal reception.
If you should mislay the remote control, then the
appliance can be turned on and off using the
manual "POWER" switch in the panel housing,
(see appliance description). When turning it on in
this way, the appliance comes on in the
maximum air-conditioning mode at a set
temperature of 20°C.
Plug your appliance in.
Lead the hot-air expulsion duct outdoors. (see
chapter "hot-air extraction options")
Turn the drainage stopcock to the temperature
control position
Turn the appliance on using the "On/Off" button.
Select the "Temperature control"
the mode button. Fig. 5.
Set the required temperature with the
buttons.
Select the desired operation mode with the
Ventilator speed button. The ventilator speed is
always set in the following order:
(flashing)
.
function with
< >
and
31