AKO 15740 Manuel D'utilisation page 36

6- Changing the thermal paper roll
AKO-15742/15752/15782 only
When a roll of paper runs out, you must put in a new one Ref. AKO-15703.
-With the unit connected to the network, open the front cover and push the release lever (1) back.
-Remove the finished roll and pull gently downwards to extract the remaining paper left in the printer.
-Place the paper roll in the position shown in the figure.
-Insert the end of the paper roll through the bottom slot in the printer until it begins to feed through. As soon as
the paper appears in the top slot, the device will stop feeding.
-Return the release lever to its initial position. The printer is now ready to print.
-Press the E key to feed the paper through.
IMPORTANT: The printer paper is thermal and can only be printed on one side. Make sure you insert it properly.
The graph paper is thermal and therefore if you wish to keep the graphs for a long time you must make
photocopies. The length of an input's graph is less than the length of a sheet of DIN A4.
1
36