switel HSIP 5700 Manuel De L'utilisateur page 16

INSTALL CAMERAS
When you are positioning the camera, bring the monitor along; it's much easier to get the camera into the
right position when you have the display handy.
1 Position the camera where you want it, plug it into power, and check video on the monitor. Move the
camera if the view is not what you want.
2 Hold the base of the camera stand where you want to mount it and mark the location of the screw
holes.
3 Use the included screws and anchors to attach the base to the wall or ceiling.
4 Tug gently on the stand to make sure it is securely in place.
MONITOR SCREEN
The monitor's screen has 3 main parts:
• Live View area. The main screen area displays live video from the camera(s).
• Pop Out Menu Tab. Tap this tab to display 4 menus that let you manage the system.
• Icon bars. Icons display on the top and bottom of the monitor screen.
Viewing Modes
The Live View area displays live video from the cameras. Each camera can display in its own section of the
screen (quadrant) or on the full screen.
There are 4 viewing modes:
• Quad mode splits the screen's image area into 4 quadrants and displays active camera video in each
quadrant. Tap the center of the quadrant to enter Single Channel mode.
• Single Channel mode displays one camera at a time on full screen. Press
channels. Tap the center of the image to return to Quad mode.
• With Scan mode, the monitor's screen and speakers are off until a camera detects motion. That camera
then displays at full screen (sound and video on) until there has been no motion for 15 seconds. After
that, the monitor screen turns off again. Press and release POWER to turn Scan mode on.
• Auto Sequence. Displays each channel automatically in sequence in full screen display. The system
defaults to Auto Sequence mode when Scan mode is turned off. Tap SEQ to turn Auto Sequence mode
off and return to Quad mode.
14
to change between the