Fermax Veo Duox Plus Manuel D'installation page 41

A) From the Monitor.
It is possible to program the monitor using the on-screen menu.
Programming the call number: Press
the dwelling number (numbers from right to left).
Each time you press + , the number increases (starting at 1) and the arrow is used for
scrolling. A white cursor indicates the entry position of the digit. Programme the correspond-
ing number and accept it using
will be indicated by a continually lit red LED.
B) From the Panel
The monitor is automatically connected to the outdoor panel by activating the camera. Enter
the calling code for that monitor from the panel. Depending on the type of panel installed:
• By pressing the corresponding button
• By entering the code + bell.
on the screen and access the screen to program
. Once the monitor address has been programmed, this
Option selected by the white line below the
icon. Pressing this
to be heard on the monitor.
From Monitor From Panel
0 0 0 0 0 1
Nº:
will cause a beep
DUOX PLUS VEO MONITOR
13