Noise/Vibration Information; Declaration Of Conformity - Bosch PWS 1000-115 Notice Originale

OBJ_BUCH-1961-003.book Page 20 Wednesday, November 27, 2013 3:12 PM
20 | English
Angle Grinder
Weight according to EPTA-Procedure 01/2003
– with vibration-damping auxiliary handle
– with standard-auxiliary handle
Protection class
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary.

Noise/Vibration Information

Measured sound values determined according
to EN 60745.
Typically the A-weighted noise levels of the
product are
Sound pressure level
Sound power level
Uncertainty K
Wear hearing protection!
Vibration total values a (triax vector sum) and
h
uncertainty K determined according to
EN 60745:
Surface grinding:
a
h
K
Disk sanding:
a
h
K
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or insertion tools or is
poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working
period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work pat-
terns.

Declaration of Conformity

We declare under our sole responsibility that the product de-
scribed under "Technical Data" is in conformity with the fol-
lowing standards or standardization documents: EN 60745
according to the provisions of the directives 2011/65/EU,
2004/108/EC, 2006/42/EC.
2 609 006 972 | (27.11.13)
PWS ... 1000-115/
1000-125
kg
2.2
kg 2.2
/II
PWS ... 1000-115/
1000-125
3 603 ... CA2 6..
dB(A) 90
dB(A) 100
dB 3
2
m/s 7.0
2
m/s 1.5
2
m/s 5.0
2
m/s 1.5
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9,
D-70745 Leinfelden-Echterdingen
Henk Becker
Executive Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
27.11.2013
Assembly
Mounting the Protective Devices
 Before any work on the machine itself, pull the mains
plug.
Note: After breakage of the grinding disc during operation or
damage to the holding fixtures on the protection guard/power
tool, the machine must promptly be sent to an after-sales ser-
vice agent for maintenance for addresses, see section "After-
sales Service and Application Service".
1000-125 CE 1300-125 CE
2.1 2.4
2.1 2.4
/II /II
1000-125 CE 1300-125 CE
CA2 8.. CA2 9..
90 93
101 104
3
8.0 13.0
1.5 1.5
5.0 6.0
1.5 1.5
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
Bosch Power Tools
3