Important - Waring Commercial MX1300XTX Manuel D'utilisation

• Clean and sanitize motor base prior to initial use and after each use.
• Washing solutions based on non-sudsing detergents and chlorine-based
sanitizing solutions having a minimum chlorine concentration of 100 PPM
are recommended.
The following washing, rinsing, and sanitizing solutions or their equivalents
may be used.
SOLUTION PRODUCT
Washing Diversey Wyandotte
Diversol BX/a or CX/A
Rinsing Plain Water
Sanitizing Clorox ®
Institutional Bleach
• In repetitive batch-processing applications, frequent cleaning of the con-
tainer will prolong the life of the blade assembly. In no case should actual
running time between cleanings exceed one-half hour.
• Do not use container to store processed foods or beverages.
To Wash and Rinse Container
1. REMOVE CONTAINER FROM MOTOR BASE. Remove lid. Rinse
container interior and lid under running water. Add washing solution to
container. Scrub and flush out the container interior and lid to dislodge
and remove as much food residue as possible. Empty container.
2. Wipe down exterior of container with a soft cloth or sponge dampened
with washing solution. NOTE: Blades are sharp. Handle carefully.
Wash lid and lid insert in fresh washing solution. Fill container one-quarter
full with fresh washing solution, cover, place on motor base, and run on
high speed for one (1) minute. Empty container.
3. Repeat step (2), using clean rinse water in place of washing solution.

IMPORTANT

IN ORDER TO MINIMIZE POSSIBILITY OF SCALDING, TEMPERATURE
OF WASHING SOLUTION AND RINSE WATER MUST NOT EXCEED 115°F
(46°C), AND QUANTITY USED MUST NOT EXCEED ONE-QUARTER
CONTAINER FULL.
IF HIGHER TEMPERATURES OR LARGER QUANTITIES ARE USED,
OBSERVE ALL PRECAUTIONS GIVEN IN THE OPERATING MANUAL UNDER
"HOT BLENDING INSTRUCTIONS", page 8.
DILUTION IN WATER TEMPERATURE
4 tablespoons Hot 115˚F (46˚C)
/gallon
Warm 95˚F (35˚C)
1 tablespoon/gallon Cold 50-70˚F
(10-21˚C)
10
To Sanitize and Dry Container
1. Wipe down exterior of container with a soft cloth or sponge dampened
with sanitizing solution.
2. Fill container with sanitizing solution, cover, place on motor base, and
run on high speed for one (1) minute. Empty container. Dislodge any
residual moisture from blade assembly by placing empty container on
motor base, and running on high speed for two (2) seconds.
3. Sanitize lid and lid insert by immersing in sanitizing solution for two
(2) minutes.
4. Do not rinse container, lid, or lid insert after sanitizing is completed.
Allow parts to air dry.
To Clean and Sanitize Motor Base
1. UNPLUG POWER CORD. Wipe down exterior surfaces of motor base
with soft cloths or sponges dampened with washing solution, rinse
water, and sanitizing solution. Prevent liquid from running into motor
base by wringing all excess moisture from cloths or sponges before
using them.
DO NOT IMMERSE MOTOR BASE IN WASHING SOLUTION, RINSE
WATER OR SANITIZING SOLUTION.
2. Allow motor base to air dry before using.
Any other servicing should be performed by an authorized service
representative.
11