Important Safeguards; Control Panel - Waring Commercial MX1300XTX Manuel D'utilisation

IMPORTANT SAFEGUARDS

When using electrical appliances, basic safety precautions should always be
followed, including the following:
READ ALL INSTRUCTIONS.
1.
2. To protect against risk of electrical shock, do not put appliance in
water or other liquid.
3. Always unplug from outlet prior to handling or cleaning.
4. This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should be supervised to ensure that they do not play with
the appliance.
5. Unplug from outlet when not in use, before putting on or taking off
parts and before cleaning.
6. Avoid contact with moving parts.
7. Do not operate the Waring
equipment with a damaged cord or plug, or after the unit
malfunctions, or is dropped or damaged in any manner. Return
it to the nearest authorized service facility for examination, repair,
or adjustment.
8. The use of attachments, including canning jars, not recommended
or sold by Waring may cause fire, electric shock, or injury.
9. Do not use outdoors.
10. Do not let cord hang over edge of table or counter, or touch hot
surfaces.
11. Keep hands and utensils out of jar while blending, to prevent the
possibility of severe personal injury and/or damage to the blender.
A rubber spatula may be used, but must be used only when the
blender is not running.
12. CAUTION: Blade is sharp. Handle carefully.
13. Always operate blender with lid in place.
14. When blending hot liquids, remove center piece of two-piece cover.
See hot blending instructions, page 8.
15. The use of ear protection is recommended during extended
operating periods.
16. Do not leave blender unattended while it is running.
17. See cleaning and sanitizing instructions, pages 9-11.
NOT FOR WATERJET CLEANING.
SAVE THESE INSTRUCTIONS
Blender or any other electrical
®
2

CONTROL PANEL

7
3
1. Power On/Off Button - Pressing this button will turn the blender on and
off. When the unit is turned on, the blue LCD backlight will illuminate and will
prompt user when the machine is ready for blending.
2. Start/Stop Button - Pressing this button once while in standby mode will
cause the blender to run. Pressing this button again will stop the blender
from running. NOTE: The blender should not be run without a container or
with an empty container.
3. Speed Controls - Gradually increase or decrease the blending speed
of the blender in 1% increments. The speeds range from 15% to 100%.
The speed controls can also set the speed of the Norm Pulse function.
NOTE: Speed settings will be saved when unit is turned off.
4. Maximum Pulse Control - Pressing this button provides a quick burst of
speed during a blending cycle. The MAX Pulse button will run the blender at
150% power (30,000 RPMs).
5. Normal Pulse Control - Pressing this button provides a quick burst of
speed during blending cycles at speeds of less than 100%. The Norm Pulse
button will run the blender at 100% power (20,000 RPMs).
6. LCD Display - This window will display all operating messages with a
sharp blue LCD backlight.
7. Program Buttons for Pre-set Beverage Stations - The blender comes
with 4 preprogrammed beverage stations. These stations consist of the
most frequently blended kinds of drinks. All stations are reprogrammable to
accommodate the user's preferences. See page 6 for details on this feature.
2
3
6
1
4
5