Error Handling; Warning Indicators - Sony VPL-VW695ES Guide De Référence Rapide

Error Handling

Warning Indicators

The ON/STANDBY or WARNING indicator lights up or flashes if there is any trouble with
your projector.
Flashing/Lighting indicators
(Lights in red)
(Flashes in red)
Both indicators flash
Note
If the symptom persists even after carrying out the above methods, consult with qualified Sony
personnel.
If the indicator starts flashing in a way of other than the above, turn off, and then turn on the power
with the [/1 (On/Standby) button on the remote control or control panel of the unit.
If the symptom is shown again, consult with qualified Sony personnel.
16
GB
ON/STANDBY
indicator
The number of
flashes
Twice
Three times
(Flashes in red)
Twice
Three times
(Flashes in red)
If there is any problem or an error message appears on the
screen, refer to "Error Handling" in the Operating
Instructions contained in the supplied CD-ROM.
WARNING
indicator
Cause and Remedy
Close the lamp cover securely, then tighten
the screws securely.
The temperature of lamp is unusually high.
Turn off the power and wait for the lamp to
cool, then turn on the power again.
If the symptom persists, the lamp may be at
the end of its service life. In this case,
replace the lamp with a new one.
The internal temperature is unusually high.
Check to ensure that if nothing is blocking
the ventilation holes or whether or not the
unit is being used at high altitudes.
The fan is broken. Consult with qualified
Sony personnel.