Ribimex PRMPC211/33/518661 Traduction Des Instructions D'origine page 25

1. Flange bolt M6X35
2. Handle fixed frame
3. Flange nut M6
4. Handle
5. Handle grip
4.3- Hose assembly
Important: use only a PVC suction ringed hose or other hose with similar quality (not included).
Assemble the intake hose joint and the intake (suction) hose (not supplied) and drain hose to the
water pump. Proceed as follows;
1. Insert the couplings into the suction and discharge hoses
2. Use the clamps and tape (not supplied) and tighten firmly.
Then screw the hose couplings to the pump suction inlet and discharge port.
3. Insert strainer in suction hoe.
4. Use the clamps and tape (not supplied) and tighten firmly
Note: Make sure the washer is properly fitted on the intake hose coupling.
If the washer of the suction hose is loosened, or the hose buckle is lost or damaged, the water will not
be pumped properly due to air leakage.
6. Rubber feet
7. Flange nut M8
8. Supporting feet
9. Flange bolt M6X35
10. Flange nut M6
11. Wheel shaft
12. Cotter pin
13. Gasket
14. Plastic wheel
- 22 -