Bestron COOL& CLEAN AAC6000 Mode D'emploi page 46

CLEANING AND MAINTENANCE - Water drainage
The device has an internal water collection tray.
When it is full, the device stops functioning and
the indication light lights up on the control panel at
"water full".
1. Turn off the device and pull the plug from the
socket.
2. Place the device on an elevation, and place a
bucket or other kind of collection tray underneath
the drain hole of the water collection tray.
3. Unscrew the lid and plug of the drain hole (figure
1, No. 12), see figure 6. The water streams from
the water collection tray in the bucket.
ATTENTION:
• Carefully move the device and keep it upright
at all times, to prevent spillage of the water
over the brim of the internal water collection
tray. During emptying, you can slant the device
slightly to remove the last water from the water
collection tray.
• If the bucket, or other kind of collection tray,
cannot collect all the water at the same time, put
the lid and plug of drain hole back. Empty the
bucket and repeat the steps.
4. If the water collection tray is empty, put the lid
and plug back in the drain hole, and make sure
it is properly closed.
Continuous drainage
If you often use the device to dehumidify the air, you
can also use the continuous drainage. Attention: continuous drainage only works in the "dehum"-mode.
1. Turn off the device and pull the plug from the socket.
2. Unscrew the lid and plug from the continuous drain hole (figure 1 No. 9), see figure 7)
3. Connect a drainage hose (not included) to the continuous drain hole, and make sure the end of the hose
is placed in a bucket, or other kind of collection tray.
4. Use the device as prescribed in this manual.
CLEANING AND MAINTENANCE - CLEANING THE FILTER
For an optimal result, you have to clean the EVA-
filter every two weeks, and replace at least 1x per
year, or more often if the filter is visibly full. Also
clean the filter before you store it for longer periods
of time, or when you use it again after a long time.
1. Turn off the device and pull the plug from the
socket.
2. Use a cross-head screwdriver to remove the
filter from the back of the device (the middle
screw, see figure 8).
3. Rinse the filter with lukewarm water, or have it
soak in soapy water.
4. Let the filter dry properly.
5. Put the cleaned (or new) filter back in the device
and fixate it.
ATTENTION:
• If the filter has not dried properly, water can enter the device. This could cause (electrical) damage.
46
EN
6
7
8