Publicité
14. Assemble the axle bracket to the outside of the angle
brackets using two 5/16" x 1" hex bolts (D) and 5/16"
nylock nuts (G). The ends of the axle bracket must point
as shown in figure 8. Tighten and then loosen the nuts
1/4 turn.
15. Tighten the nuts fastening the angle brackets to the
tray.
(D) 5/16" x 1"
HEX BOLT
(G) 5/16" NYLOCK NUT
FIGURE 8
16. Assemble the wheels to the axle bracket using a shoulder
bolt (A) and a 3/8" nylock nut (F) for each wheel. Tighten.
See figure 9.
(A) SHOULDER BOLT
FIGURE 9
17. Assemble the hitch arms to the outside of the hitch
arm mount brackets. Use two 5/16" x 1" carriage bolts
(E) and 5/16" nylock nuts (G). Do not tighten yet. See
figure 10.
ENGlISH
REAR VIEw
(F) 3/8" NYLOCK NUT
REAR VIEw
HITCH ARMS
(G) 5/16"
NYLOCK NUT
FIGURE 10
18. Turn the tray so that the front faces you. Assemble two
angle brackets (O) to the holes in the bottom of the tray
using two 5/16" x 1" hex bolts (D) and 5/16" nylock nuts
(G). Do not tighten yet. See figure 11.
(G) 5/16" NYLOCK NUT
FIGURE 11
19. Fasten the hitch mount arms to the outside of the angle
brackets at the front of the tray using two 5/16" x 1" hex
bolts (D) and 5/16" nylock nuts (G). Tighten and then
loosen the nuts 1/4 turn. See figure 12.
(G) 5/16" NYLOCK NUT
FIGURE 12
7
(E) 5/16" x 1"
CARRIAGE BOLT
REAR VIEw
(O) ANGLE
BRACKET
(D) 5/16" x 1"
HEX BOLT
FRONT VIEw
(D) 5/16" x 1"
HEX BOLT
FRONT VIEw
Publicité
