Publicité
ASSEMBlY INSTRUCTIONS
TOOlS REQUIRED FOR ASSEMBlY
(2) 1/2" wrenches
(1) 9/16" wrenches
(1) 3/4" wrench or adjustable wrench
Before assembling the aerator, lay out all of the parts and
hardware as shown on the previous pages.
Spike points are sharp. Exercise caution when
handling and working near spike disks.
1. Assemble the end plates to the inside slots at each end
of the tray using two 5/16" x 1" hex bolts (D) and 5/16"
nylock nuts (G) per end plate. Do not tighten yet. See
figure 1.
2. Assemble the lift plate (P) and the axle support bracket
to the tray using four 5/16" x 1" hex bolts (D) and 5/16"
nylock nuts (G). Do not tighten yet. See figure 1.
(D) 5/16" x 1"
HEX BOLT
(P) LIFT PLATE
AXLE
SUPPORT
BRACKET
FIGURE 1
3. Turn the tray upside down as shown in figure 2 so that
the rear of the tray (four holes in the bottom) is facing
you. Assemble two hitch arm mount brackets and two
angle brackets (O) to the bottom of the tray using four
5/16" x 1" hex bolts (D) and 5/16" nylock nuts (G). Do
not tighten completely. See figure 2.
ENGlISH
(D) 5/16" x 1"
HEX BOLT
(G) 5/16" NYLOCK NUT
FRONT VIEw
(G) 5/16" NYLOCK NUT
FIGURE 2
4. Pivot the end plate on your right side down out of the
way. Place the long end of the axle, measured from the
middle blind hole, through the pivot plate on your left
side. (If there are two middle holes, use the hole that is
in alignment with the end holes.) Fit the middle hole in
the axle down onto the tab on the axle support bracket.
See figure 3.
5. Assemble the following parts in sequence onto the short
end of the axle (as shown in figure 3):
a. A flat washer (H), short spacer (N), disk hub (L)
and spike disk
b. A long spacer (M), disk hub (L) and spike disk.
c. A long spacer (M), disk hub (L) and spike disk.
d. A long spacer (M), disk hub (L) and spike disk.
e. A long spacer (M), disk hub (L) and spike disk.
f. Two short spacers (N), a disk hub (L) and spike disk.
g. A short spacer (N).
(H) FLAT
(L) DISK
WASHER
HUB
(N) SHORT
SPACER
HOLE
FIGURE 3
5
(O) ANGLE
HITCH ARM
BRACKET
MOUNT
BRACKET
(D) 5/16" x 1"
HEX BOLT
REAR VIEw
(N) SHORT
SPIKE
SPACER
DISK
(M) LONG
SPACER
AXLE SUPPORT
BRACKET
TAB
REAR VIEw
Publicité
