Preparing To Use The Booster; Booster Location; Installation Instructions; Features - DSR PROBOOSTER DSR103 Manuel D'utilisation

3. PREPARING TO USE THE BOOSTER

IMPORTANT: AFTER PURCHASE,
CHARGE YOUR BOOSTER FOR
24 HOURS, BEFORE USE.
WARNING! RISK OF CONTACT WITH
BATTERY ACID. BATTERY ACID IS A
HIGHLY CORROSIVE SULFURIC ACID.
3.1 Be sure the area around the battery is well
ventilated while the booster is being used.
3.2 Clean the battery terminals before using
the booster. During cleaning, keep
airborne corrosion from coming into

4. BOOSTER LOCATION

WARNING! RISK OF EXPLOSION
AND CONTACT WITH BATTERY ACID.
4.1 Locate the booster as far away from the
battery as the DC cables permit.

5. INSTALLATION INSTRUCTIONS

5.1 Remove all cord wraps and uncoil the cables
prior to using the charger and booster.

6. FEATURES

2 3
1
6.1 CHARGER
Start/Stop Button
Press to immediately begin charging your
properly connected battery. If the button
is not pressed, charging should begin
in ten minutes.
LED Indicators
POWER (green) LED lit: The
charger is connected to AC power.
BAD BATTERY (red) LED:
The charger has detected a problem
with the battery. See Troubleshooting
for more information.
4 5 6 7
™
contact with your eyes, nose and mouth.
Use baking soda and water to neutralize
the battery acid and help eliminate
airborne corrosion. Do not touch your
eyes, nose or mouth.
3.3 Determine the voltage of the battery by
referring to the vehicle owner's manual
and make sure that the output voltage of
the booster is correct.
3.4 Make sure that the booster cable clips
make tight connections.
4.2 Never place the booster directly above
the battery being jumped; gases from the
battery will corrode and damage the booster.
4.3 Do not operate the booster in a closed-in
area or restrict the ventilation in any way.
5.2 After purchase, charge your booster for
24 hours, before use.
10
11
12
17
13
14
16
15
1. Spare fuse
2. Battery clamps
3. 500A fuse
4. Alarm
5. Voltmeter button
6. Voltmeter
7. Auxiliary cable port
(DSR103AUX only)
8. Voltage selector
(on back; not shown)
CLAMPS REVERSED (red) LED
flashing: The connections are
reversed.
CHARGING (yellow/orange) LED lit:
The charger is charging the battery.
CHARGING (yellow/orange) LED
flashing: The charger is in abort mode.
CHARGED/MAINTAINING (green)
LED pulsing: The battery is fully
charged and the charger is in
maintain mode.
NOTE: See Operating Instructions for a
complete description of the charger modes.
• 6 •
9. Charging port
(on back; not shown)
10. SC3DSR charger
11. Power LED
12. Start/Stop button
13. Clamps Reversed LED
14. Bad Battery LED
15. Charging LED
16. Charged/Maintaining LED
17. Charger plug