Configuration SMS
•
A SMS with the text „O1:xxxxx" or „O2:xxxxx" (xxxxx =
seconds) configures the switching time of the relays. The
STD32 saves these settings so that they are still available
after the supply voltage has been restored.
•
If the switching time has been set to 0 by a configuration
SMS the corresponding relay switches permanently at
every call. If the relay has been active before it will
afterwards
In this case a SMS with the text „O1ON" from the
configured mobile phone switches the relay 1
permanently on. A SMS with „O1OFF"
switches off relay 1. Relay 2 is reacting accordingly to
SMS messages with „O2ON" and „O2OFF".
•
With a SMS with the text „I1:xxx" or „I2:xxx" (xxx =
seconds) you can configure the time the inputs have to be
activated before the STD32 sends out an alarm SMS.
•
A SMS with the text „V1:x" or „V2:x" (x = 1 or 0) can
change the polarity of the inputs. If x=1 an alarm SMS will
be sent in case the input has not been activated for the
configured time.
•
You can activate or deactivate the Start up SMS (START-
UP ALARM) with the SMS „S:x" (x = 1 or 0).
•
The SMS „R:" is setting the STD32 back to the factory
settings.
•
To get a feedback of the actual status of the inputs and
outputs
36
be
inactive
just
send
and
a
SMS
vice
versa.
permanently
with
„ST?".