Telic STD32 Mode D'emploi page 25

• Components, modules or devices have to be build into a
housing before they are put into operation. During
installation they should not be connected to any power
supply .
•
You should only use tools on components, modules or
devices if they are disconnected from the power supply
and the electric charge, which may still be stored in some
components, inside the device has been discharged.
•
All cables and wires which are energized and connected
to the device, the module or components have to be
checked regularly for any damage of the isolation shield
or fractures of the cables. If the supply cables are visibly
damaged the device has to be taken out of operation
immediately until the faulty cable has been exchanged.
• When using components or modules it is necessary to
strictly
corresponding description of these components.
•
If a description for a private end-customer not clearly
states which electric data is valid for a component or a
module, how to wire the device, which external
components or additional devices can be connected or
which parameters these components are allowed to have,
a specialist must be contacted.
• Before putting a device into operation, it has to be
clarified, whether this device or module is meant for the
field of application. In case of doubt ask specialists or the
manufacturer of the device.
• Please note that we are not responsible for any errors in
usage or connection. Therefore we cannot accept any
responsibility for consequential loss.
observe the specification given in the
25