Festool CARVEX PS 420 EBQ Notice D'utilisation D'origine page 15

11.1 Saw blades, other accessories
In order to saw different materials quickly and
cleanly, Festool offers saw blades for all appli­
cations that are specially designed for your
Festool jigsaw.
11.2 Sawing with special base runners
The special base runners protect high-quality
surfaces against scratches and scores.
► Press in the base runner at position [7-1].
► At the same time, push the base runner for­
wards.
► Mount another base runner and push it to
the rear until it engages.
11.3 Sawing with the angle table
The WT-PS 400 angle table is used for
cutting pipes or interior and exterior an­
gles up to 45°.
Dust extraction is not possible when sawing
with the angle table!
Installing the angle table
► Remove the saw table [1-12] (see section
8.4 ).
► Position the angle table against the saw
base support.
► Close the lever [1-10].
Ensure that the angle table is firmly seated in
the guide.
Setting the angle
► Turn the adjusting wheel [8-1] to select the
required angle.
You can select the angles -45°, 0° and +45° on
the scale [8-2].
Sawing cutting depths
Risk of injury
► Select the saw blade length and cutting
depth so that the saw blade remains
plunged in the workpiece.
For 0° cuts, we recommend setting the an­
gle table to a small negative angle to guar­
antee smooth operation.
7
7-1
11.4 Sawing with the base adapter
The ADT-PS 400 base adapter is used for at­
taching your jigsaw to the Festool guide rail and
the KS-PS 400 core maker.
(20 mm) and only use cross-set saw blades
(FSG).
WARNING
8-2
With guide rail and core maker: Observe
the max. material thickness of 6/8"
English
8-1
8
15