KOBE Brillia Série Manuel D'installation Et Mode D'emploi page 11

-
Align and secure Top Vent Cover {D} and 3-1/4"
x 10" Vent Cover (removed from rear exhaust)
using 14 screws (13 screws taken from 6"
exhaust. (Figure 5)
-
Attach the 3-1/4" x 10" Exhaust {E} to rear
exhaust (located inside hood) using 10 screws
taken from rear vent cover. (Figure 6)
Hood Installation
CAUTION
: If moving the cooking range is
necessary to install the hood, turn off the power
in an electric range at the main electrical box.
SHUT OFF THE GAS BEFORE MOVING A GAS
RANGE. And use a protective covering to protect
cooktop and/or countertop from damage.
5. Remove the baffle filters/stainless steel spacers if
necessary; arrange the electrical wires to run
through the 1" diameter hole on the top or the rear
of the hood.
6. Using references on Table 1 and measurements
on page 18, center the hood in place beneath the
cabinet. Line the hood up so that it is flush with
the front of the cabinet at the point of downgrade.
7. Draw electrical wires through the cabinet access
opening.
8. Use electric drill to remove the knockout holes on
top of the range hood.
9. Place screw (provided) into the exact center of
each knockout hole. Make sure all screws are in
place before tightening screws.
CAUTION
: MAKE SURE THE HOOD IS
SECURE BEFORE RELEASING.
Wiring to Power Supply
CAUTION
: If moving the cooking range is
necessary to install the hood, turn off the power
in an electric range at the main electrical box.
SHUT OFF THE GAS BEFORE MOVING A GAS
RANGE. RISK OF ELECTRICAL SHOCK.
THIS RANGE HOOD MUST BE PROPERLY
GROUNDED. MAKE SURE THIS IS DONE BY
QUALIFIED ELECTRICIAN IN ACCORDANCE
WITH ALL APPLICABLE NATIONAL AND LOCAL
ELECTRICAL CODES.
WIRES, SWITCH POWER OFF AT SERVICE
PANEL AND LOCK SERVICE PANEL TO PREVENT
POWER FROM
ACCIDENTALLY.
-
If hood is operating normally, connect three
wires (black, white and green) to house wires
and cap with wire connectors.
-
Store wires in the wiring box.
BEFORE CONNECTING
BEING SWITCHED
Figure 5
Figure 6
ON
9