KOBE Brillia Série Manuel D'installation Et Mode D'emploi page 10

Preparation before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD,
PREVENT DEBRIS FROM ENTERING THE VENT
OPENING.
-
Decide the location of the venting pipe from the
hood to the outside. Refer to Figure 1.
-
A straight, short vent run will allow the hood to
perform more efficiently.
-
Try to avoid as many transitions, elbows, and long
run as possible. This may reduce the performance
of the hood.
-
Temporarily wire the hood to test for proper
operation before installing. If the hood does not
operate, check the circuit breaker or house fuse.
If the hood is still not working, disconnect power
supply and check the continuity of all wire
connections.
-
Peel protective film off the hood (if any).
-
Use duct tape to seal joints between pipe sections.
-
For installing under the cabinet with recessed
bottom, attach 4-inch wide wood filler strips (not
included) on each side. (Figure 2)
-
Using reference on Page 18 to measure and create
access opening for electrical wires and exhaust
under the cabinet.
Vent option installation
CAUTION:
USE HAND TOOLS ONLY. DO NOT
OVER TIGHTEN SCREWS. IT MAY CAUSE DAMAGE TO
THE HOOD.
1. Choose the required vent option. Some installation
screws are already pre-attached to the hood.
2. For 6" Round vent installation only:
-
The 6" exhaust is already attached.
Align and secure the 6" Round Plastic Collar {H}
to two screws on hood.
3. For Top 3-1/4" x 10" vent installation only:
-
Remove attached 6" exhaust (Figure 3) and
discard. Keep 13 screws to install 3-1/4" x 10"
exhaust & vent cover.
-
Align and secure Top Vent Cover {D} and 3-1/4" x
10" Exhaust {E} using 14 screws (13 screws taken
from 6" exhaust. (Figure 4)
4. For Rear 3-1/4" x 10" vent installation only:
-
Remove attached 6" exhaust and discard. (Figure
3) Keep 13 screws to install vent covers.
-
Remove duct knockout from back of the hood and
discard. (Figure 5) Unscrew 3-1/4" x 10" Vent
Cover from rear exhaust (located inside hood);
keep screws to install 3-1/4" x 10" exhaust.
UNDER CABINET INSTALLATION
(Figure 3)
Figure 1
Figure 2
Figure 3
Figure 4
8