GE AEM10 Manuel D'utilisation Et Instructions D'installation page 12

INSTALL SUPPORT BRACKET AND
9
FOAM TOP WINDOW GASKET
A CAUTION:
To prevent broken glass
or damage to windows,
on vinyl or other
similarly constructed
windows, attach the
support bracket to the
window side jam.
Attach the support
bracket with one
Type C screw.
Cut the foam top window gasket to the
B
window width.
Stuff the foam
C
between the
glass and the
window to
prevent air and
insects from
getting into the room.
NOTE: If the gasket supplied does not fit
your window, obtain appropriate material
locally to provide a proper installation seal.
INSTALL THE AIR CONDITIONER
10
IN THE CASE
Slide the air conditioner into the case by
A
the base pan. Do not push on the controls,
styrofoam air discharge housing or the
finned coils. Make sure the air conditioner
is firmly seated.
Base Pan
Installation Instructions
Vinyl
Wood
Do not press on
these areas—
damage to the
unit may result
12
INSTALL THE AIR CONDITIONER
10
IN THE CASE (CONT.)
B
Replace the 2 ground screws removed
earlier, one on each side of the case.
IMPORTANT: The ground screws must be
reinstalled to ensure a proper ground.
C Attach the front grille to the case by
inserting the tabs on the grille into the
slots on the front top of the case. Push
the grille in.
D Secure the front grille to the case by
replacing the 2 screws removed earlier.
Press on the top of the grille to help
with side screw installation.
Connect power.
E