Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Enjoying DTV broadcasts
Selecting a digital audio format
Use the following procedure to switch between the PCM and Dolby
digital audio format.
1
Press HOME MENU.
2
Select "Setup" (/ then ENTER).
3
Select "DTV Setup" (/ then ENTER).
4
Select "User Preferences" (/ then ENTER).
5
Select "Digital Audio" (/).
6
Select "PCM" or "Dolby" (/).
User Preferences
Digital Audio
Language Settings
Note
• You can select "DTV Setup" only when watching DTV channels.
Selecting languages for audio,
subtitles, and teletext
You may manually configure language settings for audio, subtitles,
and teletext.
1
Repeat steps 1 to 4 provided for Selecting a digital audio
format.
2
Select "Language Settings" (/ then ENTER).
3
Select "Primary Audio", "Secondary Audio", "Primary
Subtitle", "Secondary Subtitle" or "Teletext" (/).
4
Select a language (/).
Note
• The plasma television automatically selects the language based
on the "Country" setting (page 27) when the selected language
for audio, subtitle, or teletext is not available.
• You can select "DTV Setup" only when watching DTV channels.
Using Software Update
This function downloads and updates the system's software at the
specified timing.
Using Auto Update
With this function on, the plasma television checks if updated
software is available and then downloads it (as necessary). After
this, the system executes Add New Channels operation (page 40).
This series of operations are automatically executed at the specified
time.
1
Press HOME MENU.
2
Select "Setup" (/ then ENTER).
3
Select "DTV Setup" (/ then ENTER).
PCM
4
Select "Software Update" (/ then ENTER).
5
Select "Auto Update" (default) (/).
6
Select "On" (/).
• We recommend that you normally select "On".
• For Auto Update to start, there must be more than one hour left
to the start of the next preset recording/watching.
• 60 seconds before the scheduled update, a message prompt
appears asking if you want to carry out Auto Update or not. Auto
Update automatically starts if "OK" is selected or no selection is
made after 50 seconds.
• While an update is in progress, no TV image is output to the
external output terminal.
• To quit an update in progress, press HOME MENU.
• You can select "DTV Setup" only when watching DTV channels.
Software Update
Auto Update
Set Update Time
Start Manual Update
Technical Information
Note
09
On
43
En
Publicité
Chapitres
Table des Matières
Dépannage
