Publicité
Les langues disponibles
Les langues disponibles
Access to the filter
Take hold of the right and left side of the plate (a)
and pull down simultaneously.
Remove the filter (b) by taking hold of its hook and
pulling down.
Cleaning the filter:
• in the dishwasher
• manually: in a hot solution of water and a liquid
detergent. Rince and allow to dry completely
Important! The previous instructions need to
be followed. If not an increased fire hazard may
occur.
Recirculation (option)
If you have chosen for recirculation, please follow
the instructions below.
Cleaning indication:
--------------------------------------------------------
Indication: red LED lights up
--------------------------------------------------------
The red LED will light up after 200 working hours
(time to regenerate the Monoblock recirculation
filter). The recirculation filter is to be found behind
the grease filter.
Remove the Monoblock recirculation filter:
• Open the bottom plate with both hands and
remove the aluminium grease filter from the
hood.
• The Monoblock recirculation filter is found in
its opening in the cooker hood. Remove it from
the cooker hood.
Regenerate the Monoblock recirculation filter:
• The Monoblock can be regenerated up to 12
times. This is done in the oven.
• Place the filter in the oven for 1 hour at 120°C.
• Provide sufficient fresh air in the room where
the oven has been placed, as smells can be
released. Smells can be released when baking
certain kinds of fish. In this case it is best to
immediately regenerate the filter in the oven.
Reset the Monoblock recirculation filter:
The cooker hood (motor) must be running!
Simultaneously press + and – for 5 sec. until
the red indicator lamp flashes 3 times for
confirmation. If the programming is not carried
out, the programming is automatically set after
the chimney hood has been switched on 10 times.
Place the Monoblock recirculation filter:
• Open the bottom plate with both hands and
remove the aluminium grease filter from the
hood.
• Place the Monoblock recirculation filter is its
opening in the cooker hood.
• Put back the aluminium grease filter and close
the bottom plate.
Maintenance of the hood
Please allow the lights to cool down sufficiently
before cleaning the hood.
Use a soft, wet cloth and a mild detergent to clean
the hood.
Never use aggressive, abrasive detergents or
sponges. Bleach will damage stainless steel.
The stainless steel surfaces can be treated with
Novy Inoxcleaner (906.060) after cleaning.
Replacement of the fluorescent lighting
Remove first the electrical plug from the electrical
point.
Remove the (onderplaat)
• Open the cover plate (A) by pulling it down.
• Remove the cover plate (A) by converting the
adjusting clips (B). Don't loosen the screws
completely!
• Click the cover plate (A) loose with a light
descending push.
• When you want to replace the cover plate (A)
don't forget to replace the adjusting clips over
the plugs and to tighten the screws.
Remove the grease filter
• Remove the grease filter to get acces to
the screws witch hold the glass panels (see
maintenance).
EN 22
Publicité
